Tidal Engineering Synergy Compact, Technical Manual, Page: 134 / 346

Synergy Controller Technical Manual, Revision H
Page 134
10.0 RUN SCREEN
Press the
RUN Screen button to open the Run
screen. From the Run screen you can, Start, Stop
and Pause a program.
If a file is loaded, it will appear in the Program
screen will appear in the Run screen when the Run
screen is opened.
10.1 Loading a Program
Open File: Press this button to load a file from the Storage Card or USB Hard Disk. The
procedure is described in Section 9.1 Programming the Synergy: Loading a File . Simply select the
desired file from the Drive List / File List screen that appears.
10.2 Program Control
Run: Press the Run button to start the loaded program at the first step.
Run From: Use this button to start the program from a step other than the first step. Click on the
desired step to select it and press the Run From button.
Run Off: Use this button to run your program with the chamber outputs OFF. You can watch the
setpoint values change as the program runs to verify the program performs as expected.
Stop: Stops program execution.
Pause: Pauses program execution. The chamber will continue to run at the current setpoints.
Dyn. Edit: Dynamic Edit is used to edit the jump loop count while the program is paused.