ATTACHING HEADPIECE
1. To attach the headpiece to the table, slide it between the
headpiece mounting bracket.
2. Visually line up the hole in the headpiece slide block with
the top holes of the headpiece mounting bracket and insert the
mounting pin with a twisting motion.
ATTACHING PISTON / PRONE ARM REST
1. Swing the flexion/extension piston down toward the
off-centered slot in the headpiece slide block.
2. Remove the piston pin from the headpiece slide block and
raise the front end of the headpiece to allow the piston to
engage the off-centered slot.
3. Attach the flexion/extension piston to the headpiece slide
block by visually lining up the holes and re-inserting the
headpiece piston pin.
4. Install the remote control lever into the bottom of the slide
block by inserting the gray cable into the narrow slot and
tilt ing the cable end of the lever into the recess until it snaps
into place. Operating this lever will allow the headpiece to
lay flush with the table cushions.
Attach Crescent Arm Rest by sliding the slotted end of the
brackets over the mounting rods. Push front of Crescent Arm
Rest down so that the block plastic bars slide over the foam pads
on the Prone Arm Rest.
CRESCENT ARM REST (optional feature)
PISTON / PRONE ARM REST (continued)
6
Table Assembly
NOTE: Operating the remote control lever will allow you to
rotate the piston head to align with the off-centered slot.
