THRUSH AIRCRAFT, INC – MODEL S2R-R1340
AIRCRAFT MAINTENANCE MANUAL
Effective: 01/01/08
7-17
correct torque (100-140 inch-
pounds) and proper angle for
alignment.
D. Install left and right elevator using
P/N 40065-1 spacer, AN4-12A bolt
and AN4-11A bolts in center and
outboard hinges. Connect elevator
control arm and check travel 27
°
±1
°
up and 17
°
±1
°
down.
E. Connect elevator trims tabs and
check for proper travel.
Figure 7-10: Stabilizer Attachment to Fuselage
VERTICAL STABILIZER
A. Install forward attachment loosely
with NAS6207-68 bolt. Using either
no shims (normal) or, if a gap exist,
use one or more of the following P/N
21209T001 (.125”) and/or P/N
21209T002 (.250”) shim(s) at upper
attach and P/N 21208T001 (.125”)
and/or P/N 21208T002 (250”)
shim(s) at lower attach. Install
hardware upper and lower and
navigation light ground wire (lower
attach); tighten all vertical fin
hardware per torque table (See
Figure 2-7). Using a string pulled
tight through upper rudder hinge and
lower rudder hinge, check hinges for
alignment fore, aft, left and right. It is
permissible to add (1) P/N
40207T005 (.050”) or 40207T007
(.063”) shim between the center
hinge bearing housing and vertical
fin rear spar to achieve proper
alignment.
