Thrane&Thrane Capsat TT-3060A, User Manual

Page: 82 / 182

Menu System
Page 5-18
12Oct01
• Flow control
The flow control for the DCE interface is selected
in this entry. It is possible to select between
hardware, XON/XOFF and none.
• ‘+++’-mode When this feature is enabled, then it is possible to
switch from data mode to on-line command mode
with the key sequence ‘+++’.
•
Result codes
When this feature is enabled, the terminal will
give positive or negative acknowledge
(OK/ERROR) to AT commands.
• ARQ mode
If enabled, the terminal will establish an end to
end error correction protocol. However it
requires, that the land line supports the V.42
standard.
For more details about AT commands refer to appendix K
Contrast
The contrast in the handset display can be changed. The contrast can
be adjusted from one to eight '*' in the bottom line of the display.
Ring Setup
This menu item is used to configure the ring signal generated during
incoming calls to the handset. The ring signal is comprised of two
alternating tones. This menu contains following entries:
•
Ring volume
The ringer volume is adjusted in this entry. A
setting to “Silent” will inhibits the ring signal.
•
Tone 1
The first tone is adjusted in this entry
• Tone 2
The second tone is adjusted in this entry
• Slow Fast
The alternation speed between the 2 tones is
adjusted in this entry.