THORLABS TPZ001, User Manual, Page: 10 / 60

10
3.2 Mechanical Installation
3.2.1 Environmental Conditions
Location Indoor use only
Maximum altitude 2000 m
Temperature range 5
o
C to 40
o
C
Maximum Humidity Less than 80% RH (non-condensing) at 31°C
To ensure reliable operation the unit should not be exposed to corrosive agents or
excessive moisture, heat or dust.
If the unit has been stored at a low temperature or in an environment of high humidity,
it must be allowed to reach ambient conditions before being powered up.
3.2.2 Mounting Options
The T-Cube Piezo Driver is shipped with a baseplate fitted, ready to be bolted to a
breadboard, optical table or similar surface.
If desired, the baseplate can be removed and the unit can be stood on rubber feet -
see Section 3.2.3.
For multiple cube systems, a USB controller hub (TCH002) is available - see Section
2.2. for further details. Full instructions on the fitting and use of the controller hub are
contained in handbook
ha0146 T-Cube Controller Hub , shipped with the product.
Warning
The safety of any system incorporating this equipment is the
responsibility of the person performing the installation.
Warning
Operation outside the following environmental limits may adversely
affect operator safety.
Cautions
When siting the unit, it should be positioned so as not to impede the
operation of the control panel buttons.
Ensure that proper airflow is maintained to the rear of the unit