10
Chapter 3
Installation & Initial Software Settings
3.1
Install The Software
DO NOT CONNECT THE CONTROLLER TO YOUR PC YET
1) Go to Services/Down loads at www.thorlabs.com and do wnload the Kin esis
software.
2) Run the .exe file and follow the on-screen instructions.
Note
This section is applicable only if the T-Cube is to be used with a PC. If
your application consists only of local operation via the T-Cube front
face, proceed to Section 3.2.
When operating via a PC, direct user interaction with the NanoTrak
controller is accomplished through intuitive graphical user interface
panels (GUIs), which expose all key operating parameters and modes.
The user can select multiple panel views displaying different information
about a particular hardware unit. The multitasking architecture ensures
that the graphical control panels always remain live, showing all current
hardware activity.
Caution
Some PCs may have been configured to restrict the users ability to load
software, and on these systems the software may not install/run. If you are
in any doubt about your rights to install/run software, please consult your
system administrator before attempting to install.
If you experience any problems when installing software, contact Thorlabs on
+44 (0)1353 654440 and ask for Technical Support.
