8
HA0360T Rev E Aug 2020
Chapter 3
3.1.2 Adjusting the Cable Exit Position
The drive cable exit position can be adjusted to exit left or right as required, with an
adjustment angle of 110° and a minimum bend radius of 35 mm (1.38”).
Simply loosen the locking screw as shown, rotate the cable to the required position
and then tighten the screw gently.
Fig. 3.1 Adjusting the Cable Exit Position
Caution
The cable exit adjustment feature is for static use only, to set the
appropriate cable exit angle. It is not for use in dynamic applications to
achieve continuous flexing. The actuator should only be driven when the
screw is locked.
Cross-Head Screw
for Locking Cable Exit
110° Cable
Exit Adjustment
Min. Bend Radius
35 mm (1.37”)
