LC1 – USB / USB 2.0 CCD Line Camera / page 20
Step 4:
The math menu should appear as
follows:
Layer1 will be Layer0
*
2. First select layer for
calculation, then click Insert. Next, select the *
button. Finally, type in the number 2.
The end result should appear as follows:
Step 5:
This will bring us back to the layer
control menu. Click on the color for Layer1 to
bring up the color menu. This allows the choice
of color for the display. To change the color,
click on the color square, or use the RGB (
red,
green, blue
) sliders to make a new color.
Step 6:
To change the line type that Layer1 will
display in, click on the line for Layer1 as shown
to the right. This will allow a number of different
choices. Then click on OK to continue
The following page will show the results of the above actions on a profile of a laser
module’s collimated beam.
