14
HA0364T Rev C Aug 2022
Chapter 3
3.2.3 Using the Baseplate
The baseplate must be bolted to the worksurface before the K-Cube is fitted, as
shown below. The K-cube is then located on two dowels in the baseplate and secured
by two clips.
Fig. 3.1 Using The Baseplate
3.3 Electrical Installation
3.3.1 Rear Panel
Fig. 3.2 Rear Panel Connections
The unit is supplied with a female 15 pin D-type connector as shown above, which is
compatible with the DDSM100 brushless DC driven translation stage (refer to
Appendix A for details of pin outs)
.
