MAIN MENU
P13
En
g
lis
h
Time Offset
:
Choose
Auto
to synchronise time and time zone automatically, or
Manual
to
specify the time zone manually.
Region
:
The country cannot be adjusted because there is only one time zone within
Austria.
Time Zone
:
This setting is only available when
Time Offset
is set to
Manual
.
When switching from wintertime to
Summer Time
, at the
Manual
time setup you will need to adjust the
correct setting here.
6.2.5 energy saving setting
Deep Standby After
:
Set the time period during which the receiver will switch from standby mode to
Off mode. The receiver consumes less power in standby mode than in On mode.
It consumes even less power in deep sleep mode, but it takes about 30 seconds
to power on from deep sleep mode.
Auto Standby After
:
Set the time period after which the receiver shall automatically switch to standby
mode, if no input signal is detected during that period.
This is the additional way of reducing the energy consumption of the receiver.
6.2.6 Parental control
The Parental Control function mostly depends on information broadcasted by operator and channels. The
operator can set age restrictions for programmes according to the legislation of the country where the
broadcast takes place.
You can also change the PIN code of the receiver in this menu. Enter the current PIN code, then the new
PIN code and confirm the new PIN code.
6.2.7 factory default
For user convenience, the receiver provides the function reset to factory settings. In this menu, the PIN
code and all settings, channels and lists are reset to the factory settings.
DefAuLT Pin coDe: 0000
.
Also, the PIN code of the receiver is reset to the factory setting:
0000
. If necessary, change the PIN code in
the Parental Control menu. See section
6.2.6 Parental control
.
6.3 Timer & update
6.3.1 Timers
Use the timer function to switch the receiver on according to the defined settings.
6.3.2 software update via usb
Follow the instructions for the software update carefully in order to update the software on an USB storage
device.
noTe:
•
Please wait until the software update is completed. Avoid any actions until the update process is finished
or an error message appears.
•
Do not unplug the receiver from the mains until the software update is completed.
•
Do not disconnect the USB storage device from the receiver until the software update is completed.
Failure to follow the above instructions can lead to receiver failure and as a result the warranty will void.
6.3.3 oTA update
From time to time software updates might be necessary when the receiver is in operation mode. This
depends on continuous improvements of the receiver functions, removal of detected defects and safety
protection of the Conditional access system.
