USING THE MULTIFUNCTIONAL STEAM BROOM
ASSEMBLE THE MULTIFUNCTIONAL
STEAM BROOM
GENERAL INFORMATION
NOTE: Verify that the tank has been
filled and that all desired accessories
are connected before following
these steps.
1. Before first use, remove the
plastic cover attached to the
electrical plug, then plug it into
an easily accessible wall outlet.
2. Place the steam control dial from
the “OFF” position to one of the
following settings: LOW or HIGH
(FIGURE 10). The Power LED will
illuminate immediately to
indicate that the unit is on and
starting to heat up.
NOTE: Which steam setting to use depends on the task at hand. See
general tips for the best steam setting for the job at hand.
3. After about 30 seconds, you will hear a hum when the unit begins
to emit steam.
4. Orient the steam wand (with desired accessory if applicable)
towards the surface you wish to steam. See the section on steaming
the mop, as well as the sections on cleaning and steaming clothes
for more information.
WARNING :
Always make sure your accessories are pointed in a safe
direction (away from yourself, other people, pets, and plants) when the
appliance is spraying steam.
EN-16
