VoIP Business Phone Administrator Manual
Copyright © 2005 THOMSON
-All rights reserved
- Page 16
Chapter 2
Phone Services
2.1
Placing a Call
The following keys are used:
Phone number
SPKR
[Using the handset]
-
Once you have picked up the handset, dial tone is given to the user
-
Dial the phone number.
-
After the calling party picks up the phone, you can start the conversation.
-
Then hang-up the handset to end the call.
-
The corresponding LCD screen messages are as follows:
LCD Screen
Description of Action
Dialing:
XXXX
User may dial the phone number. Then dial
[OK]
.
Calling …
XXXX
During Call Setup, “Calling” message is displayed.
Hang Up the Call:
TEL: 1006
Mon May 10 08:24
When hanging up the call, the standby mode message is
displayed again.
Phone Busy condition:
Response:
Busy here
If callee’s phone is off hook or is using and not available, a
busy message and tone will be presented to the user.
[Using the Headset]
-
Before using the headset, turn the headset/handset switch (on the left side of IP phone)
to “headset” location.
-
Then pick up the handset and put aside to place a call and then talk to the party
through the headset. If you want to end the call, please hang-on the handset.
[Note]:
Remember that the Hook switch is still used for the call control of Headset.
-
During conversation with Headset, the
[SPKR]
key is still available for
Headset/Group listening toggle control.
- Page 16 -
Summary of Contents for ST2020
Page 1: ...Administrator Manual ...
