MEC 20 MICROPROCESSOR ENGINE/GENERATOR CONTROLLER
PM047 Rev 13 05/03/30
13
Thomson Technology
2.14. MEC 20 ASSEMBLY - SIDE VIEW
PANEL DOOR
MEC 20 PCB
MEC 20 REAR COVER
#8-32 × 3/8" MACHINE SCREW
# 8-32 INTERNAL TOOTH LOCK WASHER
1.25" ALLUMINUM STANDOFF (HEX)
#8-32 THREAD
#8-32 INTERNAL TOOTH LOCK WASHER
1/2" NYLON SPACER
(#8-32 CLEARANCE
UNTHREADED)
PEM STUD
#8-32 × 1"
G:\ENGINEER\PRODUCTS\MEC20_09.VSD Rev. 0 97/06/02
REAR
FRONT
HIGH VOLTAGE
MYLAR BARRIER
(mounts on bottom
right hand corner, as
viewed from rear)
FIGURE #7
Notes:
1. Ensure that all lockwashers are installed as shown above.
2. The high voltage mylar barrier (P/N TMW;10805;1) must be installed as shown
when the MEC 20 is installed onto the door of a control panel.
3. When the MEC 20 is installed on a door without 1” PEM studs, 1” machine
screws must be used.
Summary of Contents for MEC 20
Page 2: ......
Page 6: ...MEC 20 MICROPROCESSOR ENGINE GENERATOR CONTROLLER...
