THOMSON LDK 200, Technical Manual

Page: 13 / 68

Installation Technical Manual LDK 200 - Camera Head
2-3
Clear
Clear
A 1
Star 4P
ND1/4
B 2
Star 6P
ND 1/16
C 3
Soft focus
ND 1/64
D 4
Attaching an Adapter
The LDK 200 Camera head is a multi-role camera head
that can be used with various adapters. To attach an
adapter to the camera proceed as follow:
Caution
Be extremely careful with the connectors between the
camera head and the adapter. Do not allow the guide
pins to damage the pins of the connector.
Caution
Follow these steps in the order given. Tightening
the screws in the wrong order could result in
mechanical damage to the camera.
a. Using the rail
1
on the bottom of the camera head
as a guide, fit the guide pins
2
on either side of the
connector and the guide pin
3
at the top rear of the
camera head into the corresponding slots of the
adapter.
b. First, tighten the two horizontal screws
4
on the
top of camera.
c. Next, tighten the two horizontal screws
5
at the
front of the camera.
d. Lastly, tighten the vertical screw
6
in the handle of
the camera.
Detaching an Adapter
To detach an adapter from the camera head follow the
steps for attaching it in the reverse order.
Caution
Loosening the screws in the wrong order could
result in mechanical damage to the camera.
Note
The procedure is given for the Triax adapter
LDK 5430. Follow the same procedure for the other
adapters.
1
2
3
4
5
6