THOMSON DV7213, Reference Manual, Page: 540 / 814

E-DOC-CTC-20061027-0009 v2.0
Chapter 27
516
nat mapadd
Add an address mapping to a Network Address Translation (NAT) enabled interface.
SYNTAX:
where:
nat mapadd intf = <string>
[type = <{napt | nat}>]
[outside_addr = <ip-range>]
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{supported IP protocol} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto | inbound | outbound}>]
intf The IP interface name.
Note The specified interface must be an existing NAT enabled
interface.
REQUIRED
type The type of NAT map to be used.
Choose between:
>
napt : The map is a Network Address Port Translation (NAPT)
map or a port-shifting NAT map.
>
nat : The map is a basic NAT map or a two-way NAT map.
OPTIONAL
outside_addr The outside (typically public) IP address.
>
Inbound: This map will only apply if the destination IP address is
part of the outside address(es).
>
Outbound: Represents the address(es) to be used as source
address after translation.
Allowed values are:
>
An IP address (A.B.C.D or A.D, meaning A.0.0.D).
>
A range of IP addresses (A.B.C.[D-E]) (only for NAT).
>
An IP subnet (A.B.C.D/M) (only for NAT).
REQUIRED
for NAT maps
and NAPT
maps.
OPTIONAL
for port-
shifting
maps.