DFT-6900 Battery Activator Instruction Manual
2
Precaution
For your protection, please read this safety information completely before operating the DFT-6900. Carefully observe
all warnings, precautions and instructions.
WARNING: Servicing described in this manual is to be done only by qualified personnel. To avoid electrical shock,
do not service the instrument unless you are qualified to do so.
DANGER
Safety testing has been done on this instrument thoroughly before shipment. However,
mishandling during use could result in injury or other bad consequences, as well as
damage to the instrument. Make sure that you understand the instructions and
precautions in the manual before use. We disclaim any responsibility for accidents or
injuries not resulted directly from instrument defects.
Safety Symbols
Description of symbols used in this manual.
DANGER
Indicates correct operation to prevent an extreme hazard that could
result in serious injury or other bad consequences to users.
WARNING
Indicates correct operation to prevent a significant hazard that could
result in serious injury or other bad consequences to users.
CAUTION
Indicates correct operation to prevent possible injury to users or damage
to the instrument.
NOTE
Indicates advisory items related to performance or correct operation of
the instrument.
1 To avoid electrical shock or fire, read these precautions first before using the unit:
2
Except as explained in this manual, do not attempt to service this equipment yourself.
3
Do not operate the DFT-6900 around explosive gas or vapor.
4
Use only insulated load cables, and test leads as supplied with the DFT-6900
5
Before use, inspect the DFT-6900, load cables, test leads and accessories for mechanical damage and replace when
damaged. Look for cracks or missing plastic. Pay special attention to the insulation surrounding the connectors.
6
Remove all clamps, test leads and accessories that are not in use.
7
Do not apply input voltages above the rating of the instrument.
8
Before use, check that the selected/indicated voltage ranges on the DFT-6900 matches the local line power voltage
and frequency.
9
Proper installation is essential to the correct functioning of your analyzing software. If you have any questions
about installation, please contact us for assistance.
10
After testing battery, there is high temperature inside the main body of DFT-6900. Therefore, please keep the unit
powered on to evaporate the heat for at least 5 minutes. Do not shut down the unit right after testing. This is very
important ensure the good performance of all electronic parts inside the main body.
This manual describes the general installation and use of the test equipment. If your system has features or accessories
not addressed in this manual, please contact us.
