THOMSON DFT-6108, User Manual, Page: 6 / 27

DFT-6108 Battery Analyzer
Instruction Manual
5
Chapter 2 Operation instructions
2.1.
The Tester Power on/off
There is a power switch on the left side of the tester, dial the upper end to Power and the down end to Power
off. Refer to Boot the main menu as follows::
The main menu consists of three parts: upper, middle and lower. On the upper left is the menu name, and on the
right is the battery level indicator. The bottom edge is the time bar, and the middle is the display and operation
area;
When using the touch screen, you can tap the menu task item directly, and then tap the selected menu task item to
execute. If you are using a keyboard, use the TAB key to toggle the selected menu task item and press Confirm to
execute.
2.2. Single-Cell Test
Attach the test clip to the battery, noting the polarity of the battery (red battery clip to the positive pole of the
battery, black battery clip to the negative pole of the battery).
Select "Single Section Measurement" in the main menu
After entering the single-cell test, select the battery voltage type, battery model, test parameters, and site number
to test. The test interface is shown in the following figure: