INSTALLATION INSTRUCTIONS:
(Floor Box)
STEP 1
Orient AFM-FAS Series Floor Box so that the knock out (K.O.)
plates are aligned with the Conduit Space of the Raised Floor
Panel. The Retainer Clips must be flush against the side of the
floor box prior to placing the box into the floor. This is to ensure
the floor box is centered inside the raised floor panel (see Fig. A).
AFM-FAS Series Floor Boxes are to be used with
AFM-FAS-C-BLK
(black) or
AFM-FAS-C-GRY
(gray) Covers
(4) 2” x 1” Knock Outs
(K.O.’s) for Data Cables
STEP 2
All four Mounting Tabs must be flat against the top surface of
Raised Floor Panel. Locate both Retainer Clips (see Fig. B). Once
the floor box is in place, use a screwdriver to secure Retainer
Clips by tightening the Screw located on top of the Mounting Tab
clockwise to secure the Retaining Clip (see Fig.B). The Floor Box
should not be able to move once secured properly.
FIG. B
AFM-FAS SERIES ACCESS FLOOR MODULE
Installation Instructions
Cat. Nos. AFM-FAS-B and AFM-FAS-B-CII
TA04494 C Page 1 of 4
CAUTION
Read all Instructions before installing
the AFM Floor Box.
WARNING
RISK OF SHOCK, DISCONNECT POWER
BEFORE INSTALLATION.
Wire Tunnel
(Sold Separately)
AFM-FAS Series Access Floor Modules
Device Panels
(Sold Separately)
AFM-FAS-B
(4) 1/2 K.O.’s
AFM-FAS-B-CII
(2) Panels for 10-Pin
Modular Connector
Retainer Clip
K.O. Plate
Floor Box
Conduit
Space
Raised Floor
(Not Included)
Retainer
Clip
FIG. A
Mounting
Tab
Retainer Clip & Screw
Raised
Floor Panel
