AB
C
Model No.
TM
ERG4004 COMFORT CRIMP
®
COMPRESSION TOOL WITH SHURE STAKE
®
MECHANISM
For Installing AB & C-Flag Terminals 22-10 AWG and
Non-Insulated Terminals, Disconnects, and Splices 22-18, 12-10 AWG
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
(22-18) AB NEST
In the event the SHURE STAKE
®
mechanism must be released, please see Figure 5.
TA04529 B Page 1 of 2
1. Open handles fully.
2. Insert terminal into proper nest as shown in Figure 2.
AB Flag
- use forward nest as indicated. Place barrel
position downward and tongue pointing rearward.
C Flag
- use rear nest as indicated. Place barrel
positioned downward and tongue pointing forward.
3. Close the handles slightly to secure the terminal. Do
not deform the terminal.
4. Insert stripped wire.
5. Close handles until SHURE STAKE
®
mechanism
cycle has been completed.
For Use With AB & C Flag Terminals
22-10 AWG
1.2
(12-10) C NEST
Figure 3
Figure 2
1.1
1.0
INSTRUCTIONS FOR USE
1. Open handles fully.
2. Position terminals/splices
in proper nest as shown
in Figure 3.
22-18
- use front AB nest
12-10
- use rear C nest
Terminal barrel seam or
splice window should
face indentor.
3. Close handles slightly to secure terminal.
Do not deform terminal.
4. Insert stripped wire.
5.
Close handles until the SHURE STAKE
®
mechanism cycle has been completed.
6.
Repeat steps 2-5 on opposite end of
splice.
For Use With Non-Insulated Terminals,
Disconnects, and Splices 22-18,12-10 AWG
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
Figure 1
C Flag
AB Flag
12-10
C Nest
22-18
AB Nest