Thitronik GSM-pro, Operating And Installation Instructions

Page: 30 / 52

2.2 Control of the alarm system
GSM-pro allows you to switch the alarm system (WiPro “all in one”)
on and off.
To switch WiPro “all in one” on, send an SMS with the following text
to the number of the GSM-pro:
arm
GSM-pro responds to a successful switching process with
a status report.
To switch WiPro “all in one” off, send an SMS with the following text
to the number of the GSM-pro:
disarm
GSM-pro responds to a successful switching process with
a status report.
In operating modes 2 and 3 WiPro can be switched to the next state
respectively by calling. Afterwards, you will again receive a status report.
If you receive a theft alert in the form of a “silent alert”, you can additionally
activate sirens and flashers with the SMS command “alarm”. The alarm can
be discontinued with the “disarm” command.
2.3 Requesting a status report
The status report contains the information stated in section 2.1 and can
be requested at any time as described here. Chapter 2.5 explains how to
find your vehicle with the help of the position information.
Send an SMS with the following text to the number of the GSM-pro:
Status
GSM-pro responds to this SMS with a status report.
Another way to request a status report is described below:
Call the number of the GSM-pro (only in operating mode 0 and 1).
After several ringing tones GSM-pro ends the call and responds
with a status report.
A status report also includes the GPS status. If a GPS receiver is connected
and receives a valid position, only the position is displayed. If a GPS receiver
is connected but does not receive a valid position, “GPS no reception”
is displayed. If no GPS receiver is connected, “no GPS” is displayed. Also,
the status of both outputs is displayed, as well as the ambient temperature
in the immediate vicinity of the unit (this value can deviate several degrees
from room temperature depending on the temperature at the installation
location).
GSM-pro manual Page 11