ThinkPad Helix 20CG, User Manual

Page: 90 / 120

Table 2. Security menu items (continued)
Menu item Submenu item Value Comments
Physical Presence for Clear • On
• Off
This option enables or
disables the confirmation
message when you clear
the security chip.
Intel AT Module Activation • Disabled
• Enabled
• Permanently Disabled
Enable or disable the UEFI
BIOS interface to activate
the Intel AT module, which
is an optional anti-theft
service from Intel.
Note: If you set the Intel
AT module activation to
Permanently Disabled ,
you will be unable to
enable this setting again.
Intel AT Suspend • Enter This option is displayed
only when the anti-theft
function is activated. The
Intel anti-theft suspend
screen will be displayed
at next boot to enter the
suspend mode.
Anti-Theft
Computrace Module Activation Current Setting:
• On
• Off
Current State:
• Not activated
• Activated
Permanently Disabled:
• Enter
Enable or disable the UEFI
BIOS interface to activate
the computrace module.
Computrace is an optional
monitoring service from
Absolute Software.
Note: If you set the
computrace module
activation to
Permanently
Disabled , you will be
unable to enable this
setting again.
Startup menu
You might need to change the tablet startup settings. To do so, tap Startup from the ThinkPad Tablet
Setup menu.
Attention:
• After you change your startup sequence, you must be extremely careful not to specify a wrong device
during a copy, a save, or a format operation. If you specify a wrong device, your data and programs
might be erased or overwritten.
• If you are using the BitLocker
®
drive encryption, you should not change the startup sequence. BitLocker
drive encryption detects the change of startup sequence and locks the tablet from booting.
Changing the startup sequence
To change the startup sequence, do the following:
1. Tap Boot . The default boot list is displayed, showing the order in which devices will be started up. Even
devices that are not attached to or installed on your tablet are listed.
82
ThinkPad Helix User Guide