Just Right!
TMX-200225
2021 ThingsMatrix Inc. Confidential Information. All Rights Reserved.
6.3 Device Power Up
After the SIM card is installed, move the power switch to the ON position (Please
refer to the picture of chapter 6.1, move the power switch to the left). When the
red
LED starts blinking, the device is powered on.
Verify that the
red
LED starts blinking slowly. It may take up to 3 minutes.
6.4 Device Installation
Close the top cover after the device is powered up.
Peel one side of the supplied 3M double sided tape and place it on the bottom of the
device (optical sensor side), making sure not to cover the sensor.
Select a place where the device will be installed. Peel the other side of the tape and
place it over a clean flat surface pressing down firmly.
If the device is removed, the optical sensor will be activated immediately. The
Platform will display a
“DEVICE_REMOVED”
alarm along with the current location
data.
