![Thetford TECMA Design Series Instructions For Installation And Use Manual Download Page 55](http://html1.mh-extra.com/html/thetford/tecma-design-series/tecma-design-series_instructions-for-installation-and-use-manual_1106679055.webp)
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
T +39 0744 709071
F +39 0744 719833
www.thetfordmarine.com
55
R
ev.
V
03
Design and Flexi Line | instructions for installation and use | ENG
3.
INSTALLATION AND SERVICE
WARNING
: Read and understand the warnings listed in this document before
installing, using, or servicing the system. Failure to comply with these warnings may
cause injuries, damage, loss of the property, and electrocution.
Any modification applied to Tecma's product may result in loss of the property,
injuries, or electrocution.
TECMA SRL is not liable for damage, injuries, or death resulting from improper
installation, operations, or interventions.
TECMA SRL recommends entrusting qualified personnel with installing the
hydraulic and electrical systems.
Comply with the system standards in force.
WARNING
:
Danger of electric shock, fire, or flooding. Failure to comply with
these warnings may result in loss of property, injury, or death.
Recommendations:
▪
Always use a fuse sized according to the electric circuits.
▪
Before starting any maintenance operation, make sure that the power supply is
disconnected and that the seacocks are in the OFF position (closed).
▪
If the toilet is connected to a seacock, make sure that its safety valve is always
closed when the boat is unattended, even for a short time.
▪
For toilets that use fresh water systems connected (even temporarily) to the port
water mains, make sure that the valve in the quay connection point is always
closed when the boat is unattended, even for a short time.
▪
If the Toilet is connected to a seacock, only use marine-type fittings, which must
be secured to every connection with two (2) stainless steel straps. Inspect these
straps frequently to check the seal and, thus, prevent any leaks.
▪
If the Toilet is connected to a seacock, install a marine ball safety valve (activated
by a lever) in correspondence of the sea cock.
▪
If water fails to flow after the first two/three flushes, there may be an assembly
problem or malfunction. In this case, do not use the toilet and refer to the
"Troubleshooting" section.