Operation Panel Status
BA_TT5-L_GB_V(0).DOCX
page 34
Usage of Firmware Update
6.10.2
Remove USB memory stick from printer and plug-
in it to a PC’s USB port.
Copy a new version of Firmware ‘’xxxx.bin’’ to the Folder ‘’\LABELDIR\FW’’
Remove USB from PC and plug-in back to the printer. The printer will update the Firmware automatically
The "\ LABELDIR \ FW" directory allows only one file exists, if there are multiple files, the files will be
confused.
Don’t remove the USB memory stick out while it’s under updating with ‘’Flash Writing...’’message that
displays on LCD panel.
USB Keyboard
6.10.3
When plug-
in an USB keyboard to the printer, LCD touch panel will display “Enter Standalone”, press the
“Y” key on keyboard to entering “Keyboard Mode” operation. In this mode you can perform "Recall Label",
set "Country Code", "Code Page", "Clock Setting", "Database Setting" and "Label Edit".
By connecting a USB keyboard to the printer, if
you don’t want to enter the Standalone mode, press the
"N" key to leave. To leave Standalone mode operation, press "ESC" key to exit.
After leaving the keyboard mode, for re-entry, press the keyboard "F1" key or reboot
to display “Enter
Standalone”.
Scanner
6.10.4
When plug-
in an USB scanner to the printer, LCD touch panel will display “Enter Standalone”, tap the
“Feed” Key to entering “Keyboard Mode” operation.
Note
The USB Host port on printer does
not support ‘’USB HUB’’ function.
The USB Memory Stick supports with ‘’FAT32’’Disk Format and up to 32GB only. The certified venders
are Transcend, Apacer, ADATA, Patriot, Corsair and Kingston.
The USB Memory Stick only supports download through the printer, On a PC, user may copy entire folder
“\LABELDIR” from USB memory stick to PC or vice-versa. You can’t copy the data to USB Memory Stick
via PC individually.
*External USB Host port is for power 500 mA, is not recommended as electronics charging use.
6.11 Dump Mode Begin
For make sure provide us correct information for check what commands sent from the PC or software, please
following below steps,
STEP 1
: Let the printer enter Dump Mode
Here is how you switch to dump mode:
On the Ready Page, three function mode for setting. You can make various setting functions in FUNCTIONAL
MODE.
1. Tap
‘’Main‘’ on LCD menu
2. Tap
‘’Printer Control‘’
3. It will show Printer Control setting items such as Configuration--
→Directory--→TPH Testing--→Dump
Mode
Please select to Dump Mode.
STEP 2
: Make sure printer ready for print a label
STEP 3
: Send a label or commands which met problem to the printer
STEP 4
: Printer will print out a label with letters and numbers, please take a picture on them and send u s by
email.
To cancel (get out of) the Dump Mode, please press the FEED key, and then the printer will
automatically print “OUT OF DUMP MODE.” This indicates that the printer is back to the standby mode.
