© Thermoteknix Systems Ltd 2020
5
1
FevIR Scan 2 Product Information
FevIR Scan 2 is a telethermography system designed to perform initial body
temperature measurement for triage use. The system is intended to measure the
skin temperature of the face and in particular, the temperature of the inner canthus
of the eye, or forehead which are typically 1C (1.6F) below body core temperature.
The detection of an elevated body temperature measurement must be confirmed by
the use of a secondary evaluation methods (e.g., non-contact infrared thermometer
(NCIT) or clinical grade contact thermometer).
A statement of measurement accuracy and calibration are included with each camera
and blackbody reference unit:
The temperature measurement uncertainty (accuracy), is less than or equal to
±0.5°C (±0.9°F) over the temperature range of 34-39°C (93.2-102.2°F)
An accurate, calibrated blackbody ThermaRef 35B1, traceable to UK National
Physical Laboratory (NPL) is included with each system to ensure accuracy of
measurement and correction/compensation of any system drift. It must be installed
in direct line of sight with the camera, equidistant to the subject inspection point
and set to a temperature of 35°C on the unit controller.
The FevIR Scan camera and ThermaRef 35B1 should be left for 15 minutes after
power on to enable both units to stabilise before use.
Both stability and drift are less than 0.2°C (0.36°F) within an 8 hour time frame as
measured and tested by Thermoteknix Systems Ltd. (Data available on request).
The FevIR Scan 2 Camera FSD01 and ThermaRef 35B1 have been tested and certified
to CE and FCC certification including electrical safety and the Low Voltage directive.
The system is supplied with FevIR Scan 2 software installed on a single notebook
computer. The software should be operated in accordance with the guidance in this
Operation Manual.
