ThermoFLUX Minitherm AQUA, User And Maintenance Manual

Page: 27 / 44

Minitherm AQUA
27
5.3.3 LANGUAGE OPTIONS
Language settings are adjusted by pressing the SET button,and after that by pressing
of button 5 or 6 we choose option MENU 03-LANGUAGE . By pressing of the SET
button language menu is opened (italian,english,german,french, croatian...) in which
we can choose desired language by pressing button 1 or 2 .
When desired language is choosen, confirmation is to be done by pressing button SET .
Returning back is done by pressing button 4 ( ON/OFF )
5.3.4 STAND BY mode
STAND BY is used in two ways..
 In the case that stove shuts down because desired temperature is reached
(set ON ),
 In the case that stove modulates when desired temperature is reached (set
OFF ).
Function
STAND BY can be set ON or OFF on following way:
STAND BY mode is activated by pressing button SET , and afterwards by pressing
buttons 5 and 6 we choose desired item in the MENU 04 – STAND BY MODE . By
pressing SET we are opening options ON or OFF (choosed by pressing of buttons 1 or
2 , and confirmed by prissing of button SET ).
5.3.4.1 STAND BY mode with installed sensor for air temperature
Connection for room thermostat is delivered overbridged, which means that
contact is closed.
1. FUNCTION STAND-BY SET ON
In the case that function STAND-BY is activated ( ON ), stove will shut down when
desired temperature is reached and above by 2 degrees C , and after 2 minutes of time
pause (set in factory) TON-WAITING COOLING is displayed. If temperature do not
decrease below set temperature during 4 (four) minutes, on display is written TON-
REQUEST WAITING . When temperature of the air in stove is below set temperature
by 2 degrees C , stove will start again with ignition mode and it will work on set power.
2. FUNCTION STAND-BY SET OFF
In the case that function STAND BY is not activated ( OFF ), and that connection for
the room thermostat is not overbridged, stove will always work in power 1 no matter
which power is set. In the case that function STAND BY is not activated ( OFF ), and
connection for room thermostat is overbridged (set in the factory) stove will work in
the power chosen by the user, and when desired temperature is reached will go into
modulation mode. Stove will shut down only if the temperature in the stove is 80
degrees
C , and will start again when temperature drops down below desired
temperature.