Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
41
Chapter 3
|
Touchscreen Console setup
– If
Pause
is selected as the
Action taken
, a
Hysteresis equation
must be set to specify conditions when operations will continue.
– If
Stop
is selected as the
Action taken
, operations must be
resumed manually.
See the instructions for configuring modules in the following sections
for more information.
3.4.2 Configuring the Agitation module
Use the following information and steps to configure the Agitation
module.
To begin, locate the Agitation module on the Touchscreen Console
Home screen, and touch
Configure
. The Agitation Module
Configuration screen will appear (Figure 3.11).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.10. Example of a Low Low Alarm Interlock screen.
