ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 51 / 173

Herasafe 2030i / Maxisafe 2030i
50155215 | 41
Start-up |
Chapter 5
USB Interface
The USB port on top of the device is reserved for servicing!
Figure 24 USB Interface and Display
The USB port next to the display window enables the user to save log data and install new
software releases.
Installation Test
Do not operate the device before the installation test has been completed.

The installation inspection of the device must be conducted in accordance with EN
12469 and additionally according to DIN 12980 for Maxisafe 2020. The cabinet may
be operated as a Class II microbiological safety cabinet, in accordance with EN
12469 / 2000, if the device functions or function patterns listed below were checked
and if the test results are within the safety value tolerances specified by the
manufacturer:

Electrical safety test

Inflow speed test

Downflow speed test

Leakage test of HEPA filters

Airflow control test

Installation test according to DIN 12980:2016 for Maxisafe 2030i

A repeat test must also be performed after repairs to the device or after considerable
changes (more than 5 cm) to the location of the device.

The operator must prepare a test report or request a written test report from the
authorized test service.
Safety warranty
The operational safety of the device, particularly the personal and material pro-
tection, are guaranteed only if all safety functions of the device have been test-
ed and approved.
Thermo Electron LED will not warrant the operational safety if the device is op-
erated without performance of the required installation test or if the installation
test and repeat test are not performed by adequately trained and authorized
personnel!