Thermo Scientific Vanquish Charger, Operating Manual

Page: 62 / 88

7 • Maintenance
Page 62 Vanquish Charger Operating Manual
7.5 Transporting or Shipping the Charger
If you want to transport the Charger to a new location or if you need to
ship the Charger, first prepare the Charger for transport and then move
or ship the Charger as required. Follow the instructions in this section.
Observe the following safety guidelines:
Installation by Service Engineer only
Service personnel certified by Thermo Fisher Scientific must perform the
installation (for brevity, referred to as Thermo Fisher Scientific service
engineer).
If it is required to re-attach the Charger to the Vanquish autosampler
after transport, contact Thermo Fisher Scientific Technical Support for
assistance.
Observe all warning messages and precautionary statements presented
in
section 2.3 Safety Precautions (see page 19 ).
CAUTION—Heavy Load, Bulky Device
The Charger is too heavy or bulky for one person alone to handle safely.
To avoid personal injury or damage to the Charger, observe the following
guidelines:
• Physical handling of the Charger, including lifting or moving, requires
a team effort of two persons.
•
To lift or move the Charger, grasp the Charger by the sides. Do not
move or lift the Charger by the front door. This will damage the door
or the Charger.
Preparing the Charger for Transport
To prepare the Charger for transport, follow these steps:
1. Shut down the Charger as described in section 6.6, page 54 . In
particular, verify that the shelf and any samples were removed from
the Charger compartment before you continue.
2. Disconnect the power cord.