Thermo Scientific UCI-100, Operating Instructions Manual, Page: 28 / 62

Universal Chromatography Interfaces
UCI-50 and UCI-100
Page 22 Operating Instructions
Fig. 9: Assigning the IP properties (CmIPUtil)
4. Enter the IP address and the subnet mask for the modules to be configured. The values
depend on the settings for the adapter for the instrument LAN ( → page 20).
5. Select the module to be configured by the serial number.
6. In the Available IP Addresses window, select the IP address to be assigned to the
UCI. If it is not listed, click Add/Remove and enter the desired address.
7. Enter the required subnet mask. Verify that this is the same subnet mask is used for the
Chromeleon server PC.
In this case, when selecting the IP address of the network adapter of the server PC, be
sure that only the last digit differs from the IP address of the UCI. Otherwise, it will not
be possible to address the connected Summit HPLC devices.
Example for a valid configuration:
UCI:
IP address 192.168.60.
51
Subnet mask 255.255.255.0
Server: IP address 192.168.60. 50
Subnet mask 255.255.255.0
To configure several TCP/IP-enabled Summit HPLC devices, make sure that every
device has its own IP address. For the example, the following entries would be possible:
2. TCP/IP enabled device:
IP address 192.168.60. 52
Subnet mask 255.255.255.0
3. TCP/IP enabled device: IP address 192.168.60. 53
Subnet mask 255.255.255.0