6 Remote operation
Thermo Scientific
20
50134830_03.2012
6 Remote operation
You may also control the magnetic shaker via PC or robot station, using the
RS232 interface. This will permit you to adjust, in addition to shaking
frequency, other parameters such as running time, performance, or shaking
sequences. Depending on the transfer of up to 14 magnetic shakers can be
controlled individually and directly via a single RS232 interface.
For detailed description of the RS232 communication protocol see
enclosed interface description (Order number 50109812)
INFORMATION
PC or robot-control is only available if the
frequency selection knob (11) is set to the position
OFF.
CAUTION
Disconnect the control unit (12) from mains before
connecting or disconnecting the control line (7).
The fixating elements (3) are even electromechanically opened and locked
when the device is remote-controlled. However, the mechanism is not
controlled by the frequency selection knob (11) as in manual operation, but
via PC. The software contains commands for opening and locking the
fixating elements (3) and, if required as in the case of the magnetic shaker
TELESHAKE 1536 LIFT, for lifting and lowering the lifting pins (2).
By default, the command is preset that the lifting pins (2) are lowered and
the fixating elements (3) are locked before shaking operation is started.
After shaking operation has been terminated, the fixating elements (3)
remain locked and the lifting pins (2) remain submerged until a command
for opening and lifting respectively is given via PC.
