Thermo Scientific Sorvall ST Plus Series, Instructions For Use Manual, Page: 19 / 172

1-5
Transport and Set Up
1. 5. Connections
1. 5. 1. Mains Connection
NOTICE
Connect the centrifuge into grounded electrical sockets only.
1. Turn off the power supply switch.
2. Make sure that the power supply cable specification agrees with the safety standards of your country.
3. Make sure that the voltage and frequency are the same as the figures on the nameplate.
4. Make sure that the power supply cable is plugged in properly.
1. 5. 2. RS232
The centrifuge has a RS232 connection, which can be used to connect to a terminal device.
1. 5. 3. Ethernet
Some centrifuge models have a RJ45 ethernet connection, which can be used to connect to a Local Area
Network (LAN). Use only equipment conform to the IEC 60950-1 standard with the RJ45 ethernet connection.
1. 5. 4. USB
Some centrifuge models have an USB-A 2.0 port, which can be used with an USB drive. Use only equipment
conform to the IEC 60950-1 standard with the RJ45 ethernet connection.
1. 6. Initial Startup
Centrifuges with a graphical user interface (GUI)
In the initial startup sequence you must make some first settings:
ƒ
Language
ƒ
Unit Name
ƒ
City and Country
ƒ
Date Format
ƒ Current Date
Complete these steps before using the unit. These settings can be changed again later. Refer to “Display” on
page 3-41 .
Centrifuges with a LCD control panel
LCD control panel centrifuges are factory setup using English as preset language. Settings can be changed later.
Refer to
“System Menu” on page 4-8 .