Thermo Scientific SOLA II Flare, User Manual

Page: 107 / 164

Appendix A
Watlow EZ Zone PM6 Series
Software
Configuration
There are two ways to configure the EZ-ZONE PM6. You can use the menu
system built into the controller and configure it using the display and
appropriate keys to navigate through the system, or alternatively, you can use
the EZ-ZONE Configurator software. Instructions for both methods of
configuration are provided in the EZ-ZONE PM PID Controller user’s
manual.
The built-in menu system and configuration software have the following main
pages.
•
Setup page: Used to set up a control prior to operation.
•
Operations page: Used to monitor or change runtime settings.
•
Factory Page: Used to enable password protection, create a custom
Home Page, and perform other tasks that do not have an effect on the
control when running.
•
Home Page: The page that is displayed when the control is initially
powered up.
Parameters for the EZ-ZONE PM6 are set to the optimum values for your
application at the factory. The defaults settings are provided here in the event
the configuration is changed without authorization.
Caution
Changing the parameters may adversely affect system performance.
▲
Pyrolyzer Settings The default settings for the pyrolyzer are provided in the tables on the following
pages.
Table A–2. Pyrolyzer settings: Setup Page > Analog Input 1
Parameter Default Comment
Display Software Display Software
Sensor Type Thermocouple
TC Linearization S For Type S thermocouple
Filter 0.5 For smoothing the process signal.
Input Error Latching Off
Display Precision Whole
Thermo Scientific SOLA II Flare User Manual A-3