Thermo Scientific SAM12, Manual

Page: 150 / 176

Maintenance and Trouble Shooting Issue: 1.0
11-2 SAM12 User Manual Thermo Fisher Scientific
6. Configured Error
7. Failed to Retrieve Sound Data From Database
8. No Default Calibration Selected
9. X-Channel Failure
10. X-Channel Failure Accessing Node {0}, ID {1}
If one of these messages occurs, a fault with a peripheral device
is indicated. Normal operation of the SAM12 can be continued
when action has been taken to rectify or circumvent the
problem.
PRINTER NOT ACCEPTING DATA
- The printer refused
to accept data for over ten seconds. This may be due to the
printer being disconnected, off-line or turned off. Check the
printer and the connection to the SAM12 (see
Network
Communications (page 3-5) ).
Whilst the SAM12 is in Background Checking mode, certain
aspects of the instrument’s operation are tested repeatedly. If a
fault is detected, the SAM12 will display the appropriate
message as follows:
1. Amplifier Failure
2. Amplifier Counter Failure
3. Amplifier Counter Overflow
4. Amplifier HV Over Current
5. Amplifier HV Over Voltage
6. Amplifier HV Under Current
7. Amplifier HV Under Voltage
8. Amplifier Dead Time Saturation
9. Amplifier EEPROM failure
10. Front Lamp Control Failure
11. Rear Lamp Control Failure
12. X-Channel Failure
13. X-Channel Failure Node {0}
The fault messages produced whilst in the application will,
typically, result in the “OUT of SERVICE” and “Critical Error”
messages being displayed. Reference to
OUT OF SERVICE
(page 5-62) may assist to clear this fault and allow continued
operation
An extreme failure may result in the Window’s “blue” screen
halting further activity. This will require rebooting the
Device Error Messages
Operational Self Tests