4
Operation
Programmed Operation
4-6
Sorvall RC 3BP Plus
Thermo Scientific
Programmed Operation
Storing Selections to Program Memory
1. Establish all desired run parameters as explained above,
.
2. Press the
key to access the advanced features screens.
3. Press the
key until the following screen is in the SET DISPLAY:
4. Press the
key.
The following screen will appear in the SET DISPLAY:
5. Enter a program number.
6. Press the
key.
The SET DISPLAY will then return to the HOME screen, and that program number will appear
in the PROG # field as confirmation:
To review stored programs before overwriting press the
key. If you press the
key you will have to
go back and re-establish the run parameters before you can store them to memory.
Performing a Programmed Run
Read the Safety Information Page at the front of this manual.
1. Press the
key.
The SET DISPLAY will change to display a program number flashing in the PROG # field.
2. Input the desired program number, then press
key.
The SET DISPLAY and options indicators change to reflect the run parameters that were saved to
that program number.
Note
Single-digit program numbers 1-9 are for storing sets of standard run parameters.
Double-digit program numbers 10-15 are for storing step-runs.
Note
To prevent accidental erasure of established programs, if the entered program number has
been previously assigned, the following message will appear:
Summary of Contents for RC 3BP Plus
Page 2: ......
Page 3: ...Thermo Scientific Sorvall RC 3BP Plus Instruction Manual 50113587 6 04 2013 ...
Page 70: ......
