Ramsey Oretronic IV Tramp Metal Detector REC 4479C
Page 34
Operating the TMD IV
Overview
This section provides information about setting up and operating the TMD IV. The operator interface, including
all keys, indicators, and displays, is described. Procedures for initial setup and calibration are provided.
The operator interface to the TMD IV is a front panel on the control unit. The front panel is composed of an
LCD display panel, LED indicators across the top of the display, a row of soft-keys across the bottom of the
display, and a membrane keypad with the digits 0-
9 and “Home” and “Alarm Reset” keys. Figure
3-1 shows the
front panel.
In addition to operating from the operator interface panel, the TMD IV can communicate through the Modbus
communications protocol (if the optional Any Bus card is installed).
The TMD IV can operate using either English or Metric units
, as selected by the “Units”
option. This document
uses English units. If you change your
units’ selection after the
TMD IV is set up and calibrated, you do not
need to redo the calibrations and setup using the new units; the TMD IV will convert values.
Several languages are supported by the TMD IV. These include English, German, Spanish, Italian, and Chinese.
This section describes the components of the front panel and how they are used to set up the TMD IV.
Figure 3
–
1. Tramp Metal Detector Keypad
