Thermo Scientific LevelPRO, User Manual

Page: 30 / 128

Startup & the Setup Wizard
User Modes & Passwords
3
-
6 LevelPRO User Manual Thermo Scientific
– The fields representing the inputs will display the current operational mode of
each port. If the user connects to the detector through Com A and enters the
Engineer mode password, Com A Password Mode will display Engineer, while the
other port fields say Display List.
– The Mode Count fields indicate how many times the detector has been accessed in
each respective mode.
– The passwords for the different access levels may be changed by manually
changing them in the Password Setup section of this screen.
Note:
Passwords must be numeric only so as to be accessible when working at
the keypad display.
System Timeout
If a user does not interact with the detector for five minutes, the display will time out
and begin showing the scrolling measurement screens. Each time a button on the
keypad is pressed or the user interacts with the EZ Cal II software, the timeout period
resets to five minutes.
During standardization and calibration the timeout function is inactive and will not
occur.
The Setup
Wizard
Begin the level setup using the setup wizard. To start the wizard, click on the small
blue wizard’s cap on the task bar, underneath the View menu option.
Figure 3-3. Detector and Application Type Selection
1. Click the indicator to select the appropriate detector and application.
2. Next, select an application for the detector from the dropdown list immediately to
the right.
Selecting one of the applications – in this case, Level – will preload a number of
the detector parameters with factory defaults typical for the chosen type of
application.