Thermo Scientific HM525 NX Operator Guide
19
Unpacking the Instrument
•
Cut through the three packing straps and
remove the packing.
•
Remove the upper wooden cover (fig. 1) (item
1).
•
The hinges of the upper wooden cover are
secured with tape.
•
Remove this tape.
•
Lift the packing over the instrument (fig. 1)
(item 2).
•
Remove the upper and lower supporting
foams (fig. 1.3, 1.4, 1.5, 1.6) from the
HM525 NX.
Fig 1
Note
The upper wooden cover now serves as a ramp (fig. 1a.1) on which the HM525 NX can be moved from the
pallet to the floor by using the handle (fig. 1a) (item 2).
•
The hinges of the upper wooden cover (fig. 1)
(item 1) are inserted into the screws of the
bottom plate (fig. 1a) (item 3). The correct
side for this is marked with arrows.
•
The tool (fig. 2a) (item 2) for the height
adjustment of the setting feet of the HM525
NX is packed together with the accessories of
the HM525 NX (separate carton on the foot
rest of the HM525 NX).
•
Turn the setting feet completely upwards via
this tool so that the HM525 NX stands with
its rollers on the bottom plate (fig 1a) (item 3).
•
Via the handle (fig 1a) (item 2), roll the
HM525 NX from the bottom plate (fig. 1a)
(item 3) over the wooden cover
(fig. 1a) (item 1). In doing so, the rear side of
the instrument must face the incline (fig. 1a) (
item1).
Fig 1a
