Thermo Scientific Heratherm OGS 100, Operating Instructions Manual

Page: 37 / 88

Start-up
Preparing the Work Space
Thermo Electron LED GmbH Heratherm 5-3
Preparing the Work Space
The following work space components should be checked for cleanliness and cleaned prior to
use:
• shelf support brackets,
• wire-mesh shelves,
• work space surfaces,
• work space seals and gaskets,
Installation or Removal of the Support Rails (OMS Series only)
Figure 5-4 Support Rail Installation
The embossings at [2] and [5] act as lateral guides for the support rails, while the embossings
at [1] and [6] secure the support rails in place. For the support rails to install correctly the
retaining spring [3] must be facing upwards.
1. Place the support rail [4] on the lower embossing [6] and tilt it upwards against the work
space side wall so that the rail is positioned over the two embossings at [5] and [2].
2. Clamp the retaining spring [3] behind the upper embossing [1].
Disinfection
For details about the cleaning of the oven, please refer to the section
“Cleaning” on page 9-1 .