4
Start-up
Installing the Shelf System
4-10
Heracell Vios 160i / 250i CR
Thermo Scientific
2. Clamp the lockspring behind the upper embossing.
3. To remove the support rails, pull the lockspring tab down out of the embossing and remove the rail.
Shelf Support Installation
Figure 4-9.
Shelf Support Installation
1. Insert the shelf supports into the perforations of the support rail (1/
) with the support
bar (2/
) facing down.
2. Make sure that the two vertical elements of the shelf support are flush with the support rail.
Installing the Shelves:
1. Slide the shelves with the tilt protection device (5/
) ahead onto the shelf support. The
tilt protection is also used as a guide for the shelf.
2. Slightly raise the shelf so that the withdrawal stop (6/
) can be routed over the shelf
supports.
Summary of Contents for Heracell Vios 160i CR
