Thermo Scientific Gallery Plus, Installation Manual

Page: 32 / 67

4
Setting up
Placing rack labels
14
Thermo Scientific
Figure 8. Checking probes
Placing rack labels
If the racks are without barcodes, place the barcode labels on the racks. To place a barcode label
on the rack:
1. Make sure that the rack ID label and barcode label you are about to use have the same ID
number.
2. Stick the rack ID label on the rack as shown in the following figures.
3. Stick the barcode label as shown in the following figures. Make sure that the barcode is not
aligned on the tube position's lip and there is no gap between the lip and the barcode.
Figure 9.
Aligning a barcode on the rack
1 - Lip of the tube position
2 - Barcode
Note
Make sure you place the correct rack labels on the racks.
The rack IDs are divided as follows:
• Sample rack 9 - standard for cups and tubes: 1 - 79
• Sample rack 9 - blue for cups and tubes: 80-99
• Sample rack 18 - non-barcoded for cups: 401-449
• Sample rack 18 - non-barcoded for tubes: 451-499