Thermo Scientific Eutech DO 1730, Operation Manual

Page: 12 / 40

12 Chapter 3 | Setup Menu
Chapter 3
Setup Menu
3.1 Setup Menu Overview
Use the meter Setup Menu to customize meter settings.
In the Measure Mode, press the “Menu” key to
access the meter Setup Menu.
The first Setup Menu item (View Logs, Data Log) will
be shown. To scroll through the Setup Menu list,
press the

or

key.
a. Press the

key to scroll to the second item.
b. Press the  key to scroll to the last item.
c. The list is cyclical, so continue to press the 
key to scroll from the last item to the first item.
To change a setting within a Setup Menu item,
press the
 or  key.
a. For numeric value changes:
i. Press the

key once to increase the
value by one least significant digit/unit.
ii. Press the  key once to decrease the
value by one least significant digit/unit.
iii. Press and hold the

key to quickly
increase the value.
iv. Press and hold the  key to quickly
decrease the value.
Once a setting is changed, press the “Enter” key to
save the change.
When viewing data logs or calibration logs, press
the “Menu” key to go back to the main Setup Menu
list.
Press the “Measure” key at any time to exit the
Setup Menu and return to the measure mode.
# Setup Menu Item Description
1 View Logs
View up to 500 data log points
and active dissolved oxygen and
temperature calibrations
2 Log Export Type Set the export type as computer
or printer or turn export off
3 Export All Logs
Send all saved data logs and
calibration logs to the selected
export device
4
Temperature
Calibration
or
Manual
Temperature Input
When DO electrode with built-in
ATC sensor is connected, use
the Temp. Calibration menu to
perform a temperature offset
calibration
When DO electrode without built-
in ATC sensor is connected, use
the Manual Temp. Input menu to
enter the sample temperature
value
5 Measure Mode
Set the main measure mode to
dissolved oxygen as %
saturation, mg/L or ppm
6 DO Resolution
Set the displayed DO resolution
as 0.1 or 1 % saturation; 0.01 or
0.1 mg/L or ppm
7
Barometric
Pressure Units Set the barometric pressure units
as mmHg or bar
8 Barometric
Pressure Value
Enter the barometric pressure
value
9 Salinity Value Enter the sample salinity value
10 Read Type
Set the read type to define how
measurements are performed
and when measurements are
saved and exported
11 Timed Interval
When Timed is set as the Read
Type, set the time interval to be
used to automatically save and
export measurements
12 Calibration Due
Alarm
Set the calibration due alarm
interval; an alarm is triggered if a
calibration is not performed
within the specified time interval
13 Set Date Format
Set the date format as month-
day-year (MM.DD.YYYY) or day-
month-year (DD.MM.YYYY)
14 Set Date Value Set the day, month and year
15 Set Time Value Set the time in AM/PM format
16 Audio Mode Set the audible beep on or off
17 Sleep Mode Set the sleep mode on or off
18 Clear Data
Erase all data logs or erase all
calibration logs
19 Factory Reset
Erase all data logs, calibration
logs and settings and return the
meter to its factory default state
Setup Menu Item
Setting Options for
Setup Menu Item