Thermo Scientific Dionex UltiMate 3000 Series, Operating Instructions Manual, Page: 54 / 270

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 46 Operating Instructions
3.5.3 Configuring the Module
3.5.3.1 Initial Installation
On each configuration page for the module, check and change the settings if necessary and
select additional settings if needed. You may reopen the configuration pages later again to
change the settings ( → page 53).
Tip:
Changing the settings for a specific application in the
Commands
dialog box,
in a program file (PGM), or on a control panel will not change the settings on
the configuration pages.
For additional information about a page, click Help .
General Page
Display general information about the module:
Fig. 14: General page
• Device Type
Indicates the device model.
• Enable Virtual Mode
This check box should be cleared because Chromeleon only simulates the functions of
the module when the virtual mode is active. If the Virtual Mode is enabled, the Module
Address box will be unavailable.
• Module Address
Select the address of the module if necessary. Click Browse and then double-click the
module that you want to use on the Device List . The address is automatically entered in
the
Module Address
box. The button appears dimmed if the virtual mode is enabled.