Thermo Scientific Dionex UltiMate 3000 Series, Operating Instructions Manual

Page: 135 / 270

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Operating Instructions Page 127
5.6 Information for Operating the Column Compartment
This section provides specific information about settings and functions that should be
considered for operating the column compartment:
To learn more about ... See page ...
Turning on temperature control See below.
Activating column identification (column ID) 129
Adjusting the sensitivity of the gas and humidity sensors 130
Recording the temperature signal 131
Adjusting the Screen Brightness or Contrast 131
Section 5.5 (
→
page 107) provides information that should be considered for operating the
pump module. For information about special Chromeleon functions, see section 5.7
( → page 132).
5.6.1 Turning On Temperature Control
You can turn temperature control on and off and set the target temperature in Chromeleon
and on the column compartment display.
Tip: The column compartment has no active cooling system and thus, the
temperature in the compartment cannot be reduced below a temperature
resulting from the ambient temperature and self-heating of the module.
Therefore, the temperature set point must be at least 7 °C higher than the
ambient temperature.
If the temperature set point is too low, the column compartment may not
become ready for the next injection (in this case, the Ready property continues
to indicate NotReady).
To turn temperature control on in Chromeleon
1. In Chromeleon, open the Commands dialog box for the column compartment.
2. Select
ColumnOven
.