Thermo Scientific Dionex UltiMate 3000 Series, Operating Instructions Manual

Page: 113 / 270

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Operating Instructions Page 105
5.4.2.3.1 Main Menu
The Main menu provides top-level access to the menu structure. To open the Main menu,
show the function keys and select Menu ( → page 94).
From the
Main
menu, you can open the following menus:
• Control
On the Control menu, you can make the settings for temperature control and valve
control (see further down).
•
Information
The Information menu provides information for diagnostic purposes (see further down).
• Configuration
The Configuration menu provides information about the configuration of the column
compartment and allows you to make the required settings or change the settings
( → page 106).
5.4.2.3.2 Control Menu
From the Control menu, you can turn temperature control on and off and set the target
temperature. In addition, you can specify the switching position of the valves.
To … Select …
Turn temperature control on or off. Temperature Control
Set the target temperature. Temperature
Set the switching position for the left valve
(= liquid flow path through the valve).
Left Valve Position
Set the switching position for the right valve
(= liquid flow path through the valve).
Right Valve Position
5.4.2.3.3 Information Menu
The Information menu provides information for diagnostic purposes (read-only). Heating
Workload shows the workload of the heat exchanger.
General information about the module, such as the serial number and firmware version, are
available on the Diagnostics menu of the pump ( → page 102).