Thermo Scientific Dionex ICS-5000+, Installation Instructions Manual

Page: 49 / 174

3 • System Setup
Doc. 065447-02 12/14
41
3.6.3 Installing the TC Column ID (Identification) System
The TC electronic column ID system lets you store important column
properties on a column ID chip card. To implement the ID system, you must
complete all of the following tasks:
•
Install a column ID chip card for each column to be monitored (see
below).
•
Specify the columns you want to monitor in the TC configuration
properties dialog box (see
page 57 ).
•
Select the column properties to be monitored (see page 42 ).
Installing a Column ID Chip Card
The TC Ship Kit (P/N 064789) includes two column ID chip cards
(P/N 5710.1500). If more chip cards are needed, order the optional Column
ID Kit (P/N 6710.1505; five chip cards).
1. To attach a column ID chip card to the column,
wrap the strap around the column, insert the rivet
into one of the holes on the strap, and press to
secure the strap to the column (see
Figure 3-13 ).
Figure 3-13. Attaching the Column ID
System to the Column
2. Insert the chip card (with the Thermo Fisher
Scientific logo facing up) into the appropriate
card reader (A, B, C, or D) along the top of the
compartment (see
Figure 3-14 ).
When the chip card is installed correctly, the
LED next to the slot is green.
Figure 3-14. Inserting a Column ID
Chip Card
3. Repeat the steps above to install the other chip card.