Thermo Scientific Dionex ICS-2000, Operator'S Manual

Page: 283 / 390

Setting Up the Eluent Generator
Doc. 031857-03 4/06
B-79
Items Required to Complete the Setup Procedure
In addition to the EluGen cartridge and the EGC CO
3
Mixer, you will
need the following items to complete the eluent generator setup. Except
as noted, all items are supplied in the ICS-2000 Ship Kit (P/N 064375).
Item P/N Use To
Yellow 0.5 mL/min, 7 MPa
(1000 psi) backpressure coil 053765 Provide backpressure during
setup procedures
EluGen Cartridge Vent Line
Tubing Kit (supplied with the
cartridge) 063092 Vent the cartridge during
operation
EGC CO
3
Mixer mounting
clips
063642 Install the mixer
Phillips head screwdriver (not
supplied) n/a Install the EGC CO
3
Mixer
mounting clips
35 cm (14 in) of black
0.25-mm (0.010-in) ID PEEK
tubing 064346 Connect the EGC degas eluent
outlet and the EGC CO
3
Mixer
inlet
60 cm (24 in) of black
0.25-mm (0.010-in) ID PEEK
tubing 064343 Connect the EGC CO
3
Mixer
outlet to port
P
(
2
) on the
injection valve
Temporary waste container
(beaker, bottle, etc.) (not
supplied) n/a Collect waste during setup
procedures
10-32 fittings
10-32 ferrules 043275
043276 Complete the plumbing
connections
1/8-in fittings
1/8-in ferrules 052267
048949 Complete the plumbing
connections
10-32 to 10-32 couplers 042627 Complete the plumbing
connections