Thermo Scientific Dionex ICS-1100, Operator'S Manual

Page: 116 / 168

Dionex ICS-1100 Ion Chromatography System
106
Doc. 065289-03 10/12
5.11 Replacing the Suppressor
Refer to the suppressor manual for guidance about when to replace a suppressor.
Suppressor manuals are included on the Thermo Scientific Reference Library
DVD (P/N 053891).
1. Refer to the suppressor quick start guide (shipped with the suppressor) for
instructions on preparing the suppressor before initial use and for additional
installation details.
2. Turn off the pump from the Dionex ICS-1100 Control panel in Chromeleon.
3. Open the front door of the Dionex ICS-1100.
4. Disconnect the two eluent and the two regenerant lines from the suppressor.
5. To remove the suppressor from the component panel, slide it up to detach it
from the mounting tabs on the panel and then pull it toward you.
6. Continue pulling the
suppressor out until the
yellow connector on the
cable inside the Dionex ICS-
1100 is outside the panel (see
Figure 5-14 ).
7. Disconnect the suppressor
cable (twist the ring on the
yellow connector and pull the
two connectors apart).
Figure 5-14. Removing the Suppressor
8. Connect the cable from the new suppressor to the Dionex ICS-1100 cable
(align the pins on the two connectors and push them together).
9. Orient the suppressor with the
REGEN OUT
fitting on top and the cables to the
right.
10. Push the cables into the opening in the component panel.
Yellow
Connector