Thermo Scientific Dionex AS-DV, Operator'S Manual

Page: 58 / 132

Dionex AS-DV Operator’s Manual
48
Doc. 065259-05 10/12
positions. A message informs you that a queue or batch is currently
running. Click
Yes to continue.
4. Wait until the Dionex AS-DV carousel and sampling tip are not
moving. Then lift the top cover, remove the old vials, and replace
them with the new vials.
Do not reach into the autosampler while
the carousel is moving!
3.8.6 Inserting a Priority Sample
1. Open the currently running sequence.
2. To insert a priority sample, right-click the sample that you want the
priority sample to precede and select Insert Sample . This adds a new
sample to the sequence.
3. Enter injection information for the new sample and click File > Save .
4. If you are replacing a previously sampled vial with the priority vial,
follow these steps:
a. Open the Dionex AS-DV ePanel (in Chromeleon 7) (see
Figure 3-4 ) or Control panel (in Chromeleon 6.8) (see
Figure 3-5 ).
b. Under Reset Vial Memory , enter the position of the vial in the
Start Pos. and End Pos. boxes.
c. Click Reset Vial Range . This clears vial information (the size of
the vial installed, if any, and the volume remaining) for the
position. A message informs you that a batch is currently running.
Click
Yes to continue.
5. Wait until the Dionex AS-DV carousel and sampling tip are not
moving. Then lift the top cover, remove the old vial (if any), and
insert the priority vial in the carousel.
Do not reach into the
autosampler while the carousel is moving!