Chapter 8
Diagnostics
This chapter provides on the Diag/Service menu in the NI-FBUS
Configurator root menu. The Diag/Service menu provides access to the
Current Output, Loop Test, Trim Analog Output, Device Status, and
AI_Transducer Parameters items.
Note
If you are not using the NI-FBUS Configurator, reference the
documentation that came with your host system.
▲
Note
This chapter provides instructions using the NI-FBUS Configurator
menus, as this is the preferred way to configure the instrument. Move from
one step to the next in the configurator method window by clicking
Next
or pressing
Enter
. If your host does not support menus, reference
for a list of DensityPRO parameters.
▲
Note
For detailed discussion on any of the diagnostic items discussed,
reference the DensityPRO user guide (P/N 717784).
▲
Current Output
The steps below describe how to configure the current output.
1.
Go to
AI_TRANSDUCER > Root Menu > 6 Diag/Service > 1
Current Output > Current output setup.
2.
When prompted, remove the loop from automatic control.
3.
Max current output:
Enter the maximum current output (between 0
and 20.5 mA).
4.
Min current output:
Enter the minimum current output (between 3.8
and 20 mA).
5.
Current output hold mode value:
Enter the hold mode value for the
current output. The value is entered as a percentage of the maximum
current output.
Thermo Fisher Scientific
DensityPRO with
F
OUNDATION
™ fieldbus
Application Guide
8-1
Summary of Contents for DensityPRO
